Rachel and Vera water sprout

cults3d

Rachel and Vera are the chosen ones to test the new well named "Virgin Purifier" The the water pipe has got 5 exits: the 4 pillars and the top. close one or more exits to adjust the waterflow according to the power of your water pump. For Closing you can simply use glue or something. The exits are open by defalut so it´s easier to clean the model when using resin-printers. Also just cut off the hose connector at the size that fits your water-hose. If you are using auto support - make sure there are no supports set inside the water-pipes. delete them manually if necessary. The model works fine without them and the water-flow is much better. Update/Fix 04-2022 Thanks to a Cults community member, I was able to localize and fix an error in the surface orientation of the drainage pipe (see red rectagle in picture 6.png). For me it worked fine despite the currupted section, but some slicers (e.g.Photon Workshop) seem to get confused. So I replaced the STL with a fixed version that should work for the other slicers as well