R-XSR receiver mount + antenna tube holder (TWO VERSIONS)

thingiverse

There are TWO options here for you: 1. My original design, which has a 120 degree angle between the antennas, and that plane is perpendicular to the mounting surface plane. 2. My design REDUX, with antennas at about 81 degrees between them, and their plane lies about 30 degrees relative to the mounting plane (swept-back 30 degrees.) In the photos, the one with orange antenna tubes is the REDUX version. Print it nice and slow, with low-layer height. The original design may need supports. Use a 1/8th inch drill bit to properly size the tube holder inside. Turn the bit by hand to carefully remove material. This gives a perfect snug fit without glue. Rotate the gold IPEX connectors on the receiver to match antenna-tube direction. Feed antennas through holes, then insert antenna-tubes. Make sure the bind button faces down (open side). A dab of hot glue holds the receiver in place. DON'T FORGET TO BIND YOUR RECEIVER BEFORE MOUNTING TO YOUR QUAD!!!