R/C Controller or Robotics Controller

thingiverse

I Built a Controller and Made it Work. Printed on a Large Bed That's 220mm by 220mm. The Object Itself Measures 210mm in Length. It Was Printed at a Layer Height of .20, With a First Layer of .22 for Better Adhesion to the Heated Bed, Using a Nozzle Diameter of .3mm. Here Are the Electronics Used: A NRF24L01 Module with an Antenna Purchased from Ebay is Connected to an Arduino Pro Mini Board. Power is Provided by a 750mah 3.7v Lipo Battery With a Connector. The Gimbals Were Bought on Ebay, But You Can Also Use Ones from Hobbyking and Customize Them for Your Needs. The Potentiometers Used Are B10k Cut Down Slightly to Allow for Trim Control. Switches Are On/Off/On, with an LED in the Middle Indicating Power Status. A Safety Pull-up Switch is Connected for Center Power on. Posts for the Body Were Made from Aluminum Purchased at a Local Hardware Store. You Can Also Use Model Ones. It Works Very Well and Has a Nice 2.4ghz TX. I Hope You Enjoy This Project! Print Settings: Printer: Custom Rafts: No Supports: No Resolution: .20/.22 First Layer Infill: 20% Rectilinear Notes: Printed at .20 Layer Height, 20% Infill, Rectilinear First Layer Was .22 Height. It Was Printed with an E3d Nozzle at .3mm With a Fan for PLA Printing. First Layer Bed Temp was 70 Degrees, Other Layers Were at 40 Degrees. It Was Designed Using Spaceclaim 2016 and Rendered with Keyshot. All Files Are Repaired! Enjoy!