QX90 FPV Camera Mount and Top Plate

thingiverse

So I basically wanted a modified camera mount, then a modified top plate and also something to hold the motors both at the top and bottom. I combined the XF90 frame and the top plate claw into one piece for the top plate which now holds stop 8.5mm motors. The camera mount was extended so there's more material to hold onto the camera body. I don't use anything to hold the camera in, just the printed parts as it's tight enough. The top plate is screwed in using the front most holes and the slightly wider center holes and also the standoffs under both. Using my settings, I didn't need to make any modification to get the top plate over the motors and they fit snug but still move up and down if required just to take some strain off. Thanks to the guys who made the original parts which allowed me to make this entire thing. The top plate is in two versions: the normal one with full size motor holes that require you to use some spare rubber grommets like you use on the normal frame, and the v1.1 version with smaller holes so the grommets aren't required.