Quick Slide/Press Fridge Magnet

prusaprinters

I loved the clean design of the Zel's Refrigerator Note Toggle.  I have remixed the model, with the following changes:Uses one magnet instead of two.Uses Ø8 x 2.8 magnet (same ones used for extruder visualizers).Allows easier magnet attachment.Doesn't toggle.  Instead, you push the top to lift the arm that holds the paper;  release and the arm snaps back.Magnet has been aggressively setback from the edge, which allow paper to slide underneath the model easily.  The reduction in Mechanical Advantage enable less pressure required to lift the arm and a quieter/softer snapback.Reduced traveling angle of the arm, further quieten/soften the snapback. Matching Pen Holder at Pen Holder Fridge Magnet. To adapt the model for larger magnet.  Use your slicer:Place the face with magnet on the print bed.Add a Negative Volume same dimension as your magnet.  Drop it to the print bed.  Then use it to cover the existing magnet recess.  (Note: you may need to make the new recess a bit deeper, so the magnet don't stick out of the model)Return the model back to intended printing orientation, by placing the side on the print bed. You can check out my other prints at https://www.prusaprinters.org/social/76585-highrise-workshop/prints.  And don't forget to click the “Like” button.