Quick Flip - fast swicth between HBP and ABP

thingiverse

Switch between ABP and HBP on your Makerbot Thingomatic without disassembly, using this simple system. You'll need an additional MBI heater board for this modification. Print two Quick Flip plates and two pairs of clips, then remove the wooden bases from both the ABP and HBP. Mark four holes to be drilled on the ABP, following the placement shown in the provided images. Countersink the holes in the printed clips so that 3mm screw heads are out of the way when fully in place. Use 10 or 12mm screws or cut longer ones and file the sharp edges. Before gluing the clips, position them in their future locations and ensure precise alignment with the ABP's other half. Remove the X-stage's front and back plate, replacing them with the Quick Flip plates. Be cautious when handling the wooden parts during this process. Test the fit between clips and plates before assembling the HPB and ABP. You may need to modify the heater board clips or black plastic connector for proper clearance. If necessary, lengthen your cable connection. Enjoy your new versatile printing system!