Quick change TP Holder (Print in place)

thingiverse

I looked a quite a few quick change TP holders. Either they were a bunch of parts you needed to screw/glue together or looked like they had should have a loose pivot due to the print orientation (bridge for pivot). I figured I could do better. The Arm STL It should import in the correct orientation for printing. No supports are needed. I recommend at least 5 walls (assuming 0.4 extrusion width). 10-15% infill is ok with the wall count. Pictured example is 12% Place the Z seam at the sharpest point. I provided the left arm. Mirror the part in the slicer for the right arm. You will need to drill out the mounting hole. The design choices were drill, poorly from the hole or supports. The wall plate STL It does need to be flipped over for printing. Otherwise, print setting are not that important. Note: The design clearance for the pivot is 0.3mm. I had issues with smaller clearances even though a clearance test print indicated I could get 0.15mm to work. Your mileage may vary.