Quick adjust inductive sensor mount

youmagine

Quick adjustment mount for inductive sensor LJ12A3-4-Z/BX utilizing the second extruder mount point on the MM3. This setup employs a corner bracket spring from Ultibots to facilitate sensor retraction. The design is displayed with the sensor passing through the second extruder hole, but the bracket can be flipped around to make the sensor forward-facing. For initial setup and fine-tuning, push down on the sensor and tighten the top nut until there's some tension on the spring and the end of the sensor is near the activation point when it's not depressed. This ensures proper alignment for coarse adjustments. For more precise tuning, push down on the sensor and adjust the bottom nut to increase or decrease tension on the spring, thereby bringing the sensor closer to the bed. The design file is available for duplication and modification at https://cad.onshape.com/documents/a705aad8aa76486887c4584c/w/f42a8b37a9374904b15a1d19/e/0401a9c157ce... To print this mount, orient it on its side and omit supports.