Quest 2 Elite Strap Cable Clip(s) [Old]

prusaprinters

<p>[UPDATE]</p> <p>This design really isn't the best and I've had a second go at the idea: <a href="https://www.thingiverse.com/thing:4668735">https://www.thingiverse.com/thing:4668735</a></p> <p>Simple, short clip design to snap onto the side of the quest 2 and hold a thicker cable for use with oculus link.</p> <p>The USB-C cable I built this around was the typical Anker one from amazon. It's around 6mm thick. This clip itself isn't perfect right now, so I've included a few different lengths to experiment with how well the clip stays on when the strap bends/moves. You could always try two smaller clips, run tape across the back of the clip (on to the elite strap), or use pc cable-management velcro ties. ;)</p> <p>If you'd like any more changes/alternatives, send me a message. ♪</p> <p>Inspired by: "Bionik Mantis mount" from sax_kun:<a href="https://www.thingiverse.com/thing:4626447">https://www.thingiverse.com/thing:4626447</a> &amp; "Oculus Cable Clip" by mike-vom-mars<a href="https://www.thingiverse.com/thing:4015669">https://www.thingiverse.com/thing:4015669</a></p> <hr/> <p>Printed on Prusa i3 MK3S at 0.3mm layer height and 15% infill.</p> Category: Electronics