Quanum DIY FPV Goggle v1 end for Boscam RC305

thingiverse

These are a cap for my FPV goggles. Inside, you'll find a holder for the Boscam receiver. I've made a hole and added some heat slots to accommodate it, as it tends to get hot within an hour or two. I'll post a picture of it once I've assembled everything. To install your Boscam receiver inside this cap, simply place it there without gluing it in place; you'll find space for cables on the other side. After that, apply some Sugru or hot glue around the corners between the cap and goggles to secure them together. That's all! Print Settings: Rafts: Don't worry about it Supports: No need for any supports Infill: Use 30% infill or more Notes: Print five shells in total. This will provide better stability.