Quanum Cyclops Hatch Cover with OLED

thingiverse

This is a hatch cover for Quanum Cyclops FPV goggles with a hole and holder for 0.96" OLED display as used with Cyclop+ firmware mod https://github.com/Dvogonen/cyclop_plus To remove the old hatch, open goggles and use craft knife to pry tabs away from inside. You might need to shave a little bit of plastic off them. Print Settings Printer: Hitctop I3 Rafts: No Supports: No Resolution: 0.3 Infill: 100% Notes: I designed with support to be cut off for latch, printed in PLA at 100% but shouldn't matter as it's so thin. Post-Printing Latch: Snip off support for latch in stages until you get it to where you want it to be How I Designed This Sketchup: It's not a perfect fit, but I couldn't get the same geometry in another design package, but it's close enough for me.