Quadwich180 - Quadcopter Sandwich

thingiverse

This is a multilayer "sandwich" quadcopter, 180 sized, greatly inspired from Sigan 180 and Bauerman design. Follow me on Twitter & Facebook to see my other design progress: https://twitter.com/hicwic https://www.facebook.com/hicwicen Designed to be easily printed with no supports needed. It fits on a 200x200 printer bed. It's made to fit 1806 or 1804 motors (M2 motor screw hole) and 4 inch props. Camera support is made to be sandwiched with 30mm spacers between top and hat part. Three mount angles are available: 0, 15, and 30 degrees. BUILD INSTRUCTIONS Part List: * 8x M3x8 screws * 16x M3x6 screws * 4x 30mm spacers (alu or nylon) 1. Screw the bottom plate to the spacer from downside with M3x8 screws directly into plastic. Do not overtighten! 2. Screw the 30mm spacers to top plate from inner side. 3. Install electronics components. 4. Screw top plate to spacer from upperside, directly in plastic with M3x6 screws. Do not overtighten! 5. Screw Hat to 30mm spacers with M3x6 screws. UPDATE 28/06/16 - 12h08: A new top has been added to the remixes with a buzzer holder and battery delimiter. UPDATE 17/06/16 - 00h10: Spacer v7 has been replaced. A sightly bigger hole for FPV antenna has been added, along with reinforcement around the FPV antenna hole. The Facebook address for followers has also been added. UPDATE 11/06/16 - 23h50: Top v9 has been replaced. Motor main hole has been reduced to fit 1804-1806 perfectly. A version with an extended XT60 holder has been added, along with some build instructions. UPDATE 10/06/16 - 22h12: Hat v6, Top v6, and camera support V4 have been replaced due to a problem in the front screws position. These versions are deprecated. Feedbacks are welcome. Print Settings: * Rafts: No * Supports: No * Resolution: 0.2-0.3 * Infill: 15-20%