Quadrysteria QR200 Rx Antenna Tubes Mount Bracket

thingiverse

I mount this bracket around the rear-most vertical support in the QR200 chassis. To secure it in place, I apply some servo tape to the bottom of the bracket. The X4R-SB receiver fits perfectly into the bracket's receptacles, and I feed the antenna wires up through the holes in the front of the bracket as I slide it onto the vertical support. Then, the 1/8" antenna tubes slip over the antenna wires and into their designated slots. Print Settings Printer Brand: MakerBot Printer: MakerBot Replicator (5th Generation) Rafts: It doesn't matter how they're set up; I usually leave them off. Supports: Since my prints don't require any, this option is always disabled. Resolution: I choose high resolution, as it's just a personal preference of mine. Infill: I used 30% infill for this particular print.