QuadLock Mag Head Charging Stand

thingiverse

I combined the <a href="https://www.thingiverse.com/thing:3624874">head of Tronnic's Quad Lock stand</a> with the <a href="https://www.thingiverse.com/thing:4813802">base of Ponkabonk's Quad Lock stand</a>. I added a hole near the top to allow passthrough of a USB cable which plugs into the <a href="https://www.quadlockcase.com/collections/accessories/products/mag-wireless-charging-head?variant=42042648887467">Quad Lock Mag Head wireless charger</a>. I also added a little open storage area on the bottom of the stand for things like the <a href="https://www.quadlockcase.com/collections/accessories/products/phone-ring-stand?variant=31764239974475">Quad Lock Phone Ring</a>, which you have to remove in order to use the Mag Head charger. All was done within Tinkercad because the extent of my CAD ability is the utilization of Carboard Aided Design. Stand seems to stay upright with the Google Pixel 7 Pro attached. Haven't seen a need to add 3M tape or anything. You will need the <a href="https://www.quadlockcase.com/collections/accessories/products/replacement-360-gimbal-adaptor?variant=42042648527019">360 to Gimbal Adaptor</a> and the <a href="https://www.quadlockcase.com/collections/accessories/products/mag-wireless-charging-head?variant=42042648887467">Mag Wireless Charging Head</a>. The knob will need an M4 nut inserted/pressed (I prefer the brute force method of a hammer and punch) into it in order to thread it on. I also recommend adding an M4 washer between the knob and the stand. I did 35% infill with zig-zag. I'm sure 20% infill would be enough. I just wanted it to have a bit more weight. Print the stand as is. No need for supports or bed adhesion stuff. I printed the knob and the stand at the same time. No issues. Took around 6 hours to print.