Quadcopter Launch Pad

thingiverse

This is a redesign of a Launchpad I discovered on Thingiverse, accessible via https://www.thingiverse.com/thing:2393056. The original design had the drawback that the arms would gradually slide down over time, so I implemented some knobs to prevent this issue. However, one downside to this modification is that you can only adjust the angle in 15-degree increments. To assemble this redesigned Launchpad, you will need two M4 screws and two winged nuts for the arms, as well as a single M3 screw to secure the two feet together. It's essential that the screw turns freely within the foot but remains fixed in the arm. Given the small size of the knobs, I strongly recommend printing with a layer height of 0.1mm and utilizing a small nozzle (I employed a standard 0.4mm nozzle) to achieve accurate results. In general, you will require a well-tuned printer for optimal performance. If you encounter any difficulties, consider printing at 150% scale; however, keep in mind that this will necessitate the use of larger screws than usual.