Quadcopter Frame

thingiverse

This is a custom quadcopter frame I designed on Solidworks after the original frame for my quadcopter broke. Using four wooden booms, you can assemble the quad with a friction fit - this was printed in ABS so the friction fit might not be as good for PLA, but a little hot glue would fix this. The included STLs are: * The motor mounts * The landing gear * An above-frame table for cameras and GPS * A central frame that holds a 3S 2200mAh Turnigy Lipo battery and all supporting electronics What's needed is: * All the motors and electronics for a quad (motors, ESCs, receiver, battery, power distribution board, flight controller) * Four wooden booms measuring half an inch by half an inch in cross-section, any length you desire.