Quadcopter electronics stack mount (flight controller, power module, receiver)

thingiverse

This is my design for a mounting bracket that holds all the essential electronics of my quadcopter. My goal was to integrate the flight controller, receiver, and power module into the center of a small F330 frame. There are three distinct components: The fc_base is the lower part that securely holds the BEC power module and FrSky receiver in place. It's mounted directly onto the copter base plate using 50mm mounting holes. To accommodate a battery strap underneath, I used additional nuts as spacers. Next up is the fc_mount, which serves as the middle part that cradles the flight controller. This component also adapts the mounting holes from 50mm to 30mm, providing a snug fit. Last but not least, there's the fc_cover, an upper part that encases and secures the flight controller in place. Here are some links to the specific electronics I used for this project: * NAZE32 F3 Flight Controller * FrSky X4R-SB Receiver * APM power module with BEC To assemble everything, I drilled holes into the bottom plate of a F330 Frame and attached it using nylon screws. The design is still in progress, but so far, everything fits together seamlessly. There's likely room for further refinement to make it even better. **Print Settings** * Printer Brand: RepRap * Printer Model: Kossel * Raft: No * Supports: No * Notes: Standard print settings should work fine; no raft or supports are necessary, making this project very easy to print.