Quad MicroSciSky 6mm Motors

thingiverse

This is a frame I crafted to fit a micro scisky fc, 6x15mm motors, and eachine e010 standard 30mm props with a 150mAh battery pack. I used hot glue to secure the fc and motors firmly in place. Filament used was Colorfabb_XT-CF20 on a Prusa I3 setup with bowden extrusion. Splicer utilized was Simplify3D 3.1.1 with 50% support infill separated by .7mm from the sides and 1 layer upper vertical otherwise it's a real pain to remove completely. Frame weight is precisely 17g. Print Settings Printer Brand: Prusa Printer: Prusa Steel Rafts: No Supports: Yes Resolution: .2 Infill: 70% Post-Printing Sanding was done with light sanding; 80, 180, then 600 grit successively. How I Designed This Custom Section Battery Connector Crazily enough, a battery connector was lying around that must have been obtained from JCar.