QKK Fenice V0.2x 250mm FPV Atail quadcopter

thingiverse

This is the latest upgrade of my QKK Fenice.\nNow the arms feature enhanced reinforcement using an 8mm carbon tube, the CAM becomes easier to install and tilt, the FC mounts on the same plate with the other electronics for straightforward wiring, and even more upgrades ;-\nI built it with this setup:\nMotors: 1806 2400KV\nFC: Flip32\nFirmware: Cleanflight 1.9 PC3 with a custom motor mixer design\nESC: 12A, blheli 14\nBattery: LIPO 3S 1300mAh 45/90C\nPropellers: 5040\nAomway Mini 200mW VTX and FPV Tuned 600TVL Camera Combo\nIt demands a 35x35mm power distribution board with a directly soldered XT60 connector\nPrint Settings\nPrinter Brand:\n RepRap\n \n Printer: \n Rostock Mini Pro\n \n Supports: Yes\n \n Resolution: 0.24\n \n Infill: 60% structural, 20% other material\n \n Notes: The front canopy has two co-molded nuts for this reason you have to insert a pause into the g-code program so you can place the nuts in the hexagonal cavity.\nPost-Printing\ How to place the nuts \ \ \ All electronics are mounted on the same plate\ The printed components\ The Flip32 board\ The power distribution board (PDB)\ CAM is locked with hot glue \ \ \ \ The arms are secured by a zip tie I prefer to break an arm rather than damage the motors \ Cleanflight settings \ Important note the motor numbers do not match a standard quadcopter \ PID controller \n RC rate