QKK Fenice V0.12 250mm FPV Atail quadcopter

thingiverse

I've uploaded the V0.2x version here: http://www.thingiverse.com/thing:1252291. This is my all-printed tail quadcopter's first flying model. I built it using this setup: Motors: 1806, 2400KV FC: Flip32 Firmware: Cleanflight 1.9 PC3 with custom motor mixer ESC: 12A, BlHeli 14 Battery: LIPO 3S, 1300mAh, 45/90C Propellers: 5040 It's ready for FPV because it can hold a camera on the front and a VTX on the back. A 35x35mm power distribution board with a directly soldered XT60 connector is required. Update: As requested, I've added 220X motor arms since they haven't been tested yet; please report any issues you encounter. Watch this video: https://www.youtube.com/watch?v=7Cnoyy8tnug Print Settings: Rafts: Not Required Resolution: 0.2mm Infill: 60% structural, 20% infill Notes: To attach the front canopy's co-molded nuts, you need to insert a pause in the nc program to fit them into the hexagonal cavity. Post-Printing Instructions: How to Attach the Nuts: The flight controller is installed inside the frame. The power distribution board has an XT60 connector visible here. Cleanflight Settings: Note that motor numbers differ from standard quadcopter configurations! PID Controller Rc Rate