Qidi X-Plus Spool Mount

cults3d

Spool Holder for Qidi X-Plus Machine. This design utilizes factory spool holder cradles to securely fasten the mounts, allowing it to be used in either direction - either by attaching the tube to the rear top or positioning it over the machine's top with or without the cover on. The spool width measures approximately 3-1/2 inches, placing a standard spool about 5 inches behind the machine. This design was adapted from another remix holder created for a different machine, likely originating from Thing ID 1832235. A search of this ID confirms its existence. To assemble this spool holder, you will need: Mount sides (both, mirrored) 4 bearing pins that may require gluing if loose 4 standard 608 skate bearings 10 inches of 3/4" schedule 40 PVC pipe 4 standard schedule 40 3/4" PVC couplers (trim a few millimeters off one end of each for increased spool space and adjust the pipe length) 4 standard 3/4" to 1/2" bushings The total cost of the PVC parts is approximately $5 USD. Alternatively, you can print the design from Thingiverse (https://www.thingiverse.com/thing:3854517) created by Chad, which should fit perfectly with minor adjustments.