QIDI Tech 1 - Glass Bed Clip

thingiverse

I recently upgraded my QIDI Tech 1 glass bed, and while it grips well when heated to 90c for PETG prints, it can still shift under enough pressure. To prevent any issues, I designed these clips to slide onto the nut at the bottom of the bed, ensuring a square fit. This way, I can avoid any potential problems that might arise from uneven bed alignment. I printed these clips in PETG with one support at the C-clip area, just in case. Since the bed doesn't heat up that hot for PLA prints, you could use this material as well; however, I worry that the PLA might warp with frequent use.