Qidi Tech 1 Cable Cover / Protector

prusaprinters

<p>I wanted to remix this cover as the original design kept popping out when the wires pulled upwards (build plate returning to the home position for example).</p> <p>This design incorporates a lip at the bottom and as such is best printed in TPE / TPU to allow a bit of flexibility to fit. Once installed its a snug fit an going nowhere :)</p> <p>The internals &amp; capping section (that allows the wires to pass through) does not now require any supports also due to the chamfering. Just a small amount of support advisable for the perimeter to ensure the lip is nice and accurate.</p> <p>Will share my basic settings in the section below as had a lot of trouble printing with TPE until these were dialled in...now printing very well :)</p> <h3>Print Settings</h3> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div> <p><strong>Resolution:</strong></p> <p>0.25</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>15%</p></div> <p><strong>Filament:</strong> Technology Center TPE Black</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>4x Top &amp; Bottom solid layers,<br/> 3x Outline Perimeters, <p>Temps: 70degC Bed, 220degC Nozzle</p> <p>Print Speed: 70mm/s</p> <p>I used a single brim layer at 0.4mm offset which peeled away nicely.</p> </p></div></p></p> Category: 3D Printer Accessories