Qidi i-fast Hood Storage Brace

cults3d

I printed these to secure to the side of the printer so I had a place to store the hood. I printed 4 but 2 on the bottom and one at the top would work just as well. I used 2 sided tape to secure them but used super glue to glue to 2 sided tape to the mounts themselves as well as roughed the surface up a bit with sandpaper. I used a lighter to slightly heat the tape on the side that attaches to the printer to ensure strong adhesion. Print one at a time to ensure best results. To print flex well on the i-fast, I shimmed my extruder gear tension spring by 3.5 mm using a piece of hard rubber. I have a video of the upgrade posted to youtube under my channel. MeliorateWithNate