Qidi i-fast Front Gap Cover/Vent

thingiverse

This was created to fill the front gap in the Qidi i-fast. It simply clips in along the inner edge of the door frame. Two sided tape can be used to secure the bottom and to secure the two pieces together. Each vent will cover half of the gap so you will need to print two. I will eventually remix this to flare out a bit at the bottom edge to follow the contour of the printer a bit more tightly along the edges but these work well and leave very little space once installed. I printed them using a tough PLA. Time will tell if they warp once I crank the heat up in the chamber but at 80 degrees celsius they had no issues.