QIDI Glass Bed Clips

thingiverse

QIDI Glass Bed Upgrade. NEW CLIPS ARE HERE https://www.thingiverse.com/thing:2480107 Print Settings Printer: QIDI Tech Rafts: Doesn't Matter Supports: Yes Resolution: 0.2 Infill: 20% Notes: Print pieces and arrange them in the best way for you. I use a dab of superglue on the side of the clip where it meets the aluminum bed to hold it secure, as screws tend to loosen up. Do not glue the bottom where the heater is. This system works well if you remember to position the clips so the plate is held tight to one side and cannot move. Post-Printing Warning Make sure the bed leveling screws are tightened down enough for plenty of clearance between glass and nozzles. Breaking the plate will result if you forget this step. DO NOT spray hair spray in your printer. Coat the glass with spray first, then put it in the printer. I have recoated mine 12 times before needing to clean the glass and start over. Custom Section Glass Bed Order a 230mm X 150mm X 3mm Borosilicate glass plate from Ebay. Print Clips. Remove blue QIDI 3M tape and clean with solvent. Install clips at each corner by removing the nut from the bottom of the heat element, then reinstall the screw and nut. Insert the glass into the back clips, push it down and back simultaneously to get the plate locked in place.