Qi Wireless Charging Stand - Remix for longer phones

prusaprinters

<p>This is a remix that I made to extend the legs of David H's Qi Wireless Charger Stand so that the charger would line up with the part of my Galaxy S20+ to allow for wireless charging. The original design from David H fits shorter phones, but the many of the newer Galaxy phones are longer, so the charging pad would sit too low to transmit the charging signal from the Qi to the phone. On the original design, the base of the cradle to the middle of the Qi pad was 65mm; on this remix that distance is extended to about 77mm. I also increased the angle so it's a little more upright, keeping the centre of gravity for the (heavier) phone and Qi charging pad under the base so it won't fall over easily. The base and Qi cradle are relatively unchanged (I didn't just stretch the model as the Qi mount would be elongated too); the middle leg section was extended to fit longer phones. The overall finish is not quite as smooth as the original but you have to look fairly close to see the imperfections of my changes.&nbsp;</p><p>My print settings were as follows:</p><p>Material: PETG, transparent blue</p><p>Layer Height:0.2mm</p><p>Infill: 20%</p><p>Other: I used a good sized brim for support, and tree supports. It may print ok without tree supports (I haven't tried). PLA should also work; I still get some stringing with PETG and tree supports so my print shows some imperfections.</p>