Qi Phone Charger / Holder (table top / wall mount)

prusaprinters

I build this qi charger so I could charge while viewing on my night stand but also found I could print the body/back pieces, glue them together with super glue and mount it on a vertical surface using double sided tape.  I also wanted something I could just drop my phone in to and it would ‘auto align’ with the help of gravity and the design.Table surface - there are two bases, one tilts away 10 degrees for easier viewing when laying down.  The other base holds the holder vertical which may be better looking to some.Wall mount - print just the body and back and use super glue to hold together and mount with double sided tape.  This is nice if you don't have a night stand to use the charger with the base.Left or Right - I uploaded two sets of stls. One is the original you'd use if laying on your right side while viewing. Those named with 'left' are the opposite(what you'd print if laying on your left).Gap for USB headphones while phone is in holder.The body slot where the phone sits has a 13mm wide gap and the qi charger plate within the base is located such that it should work for most phones. Tested on iphoneX and Pixel XL 3.Materials/hardware needed:(3) 25mm M3 screws (https://www.aliexpress.com/item/10000150053486.html)(1) Qi charger board ( https://www.aliexpress.com/item/32997283422.html - order multiple for cheaper per unit shipping )Super glue (glue back to body for tighter fit if desired - https://www.amazon.com/Bob-Smith-Insta-Cure-Super-Thin/dp/B001NI4JWI/ - this will last you a while :) )(4) 10mm rubber feet ( https://www.amazon.com/Rok-Hardware-Cabinet-Furniture-Diameter/dp/B00K6RZ9Q2/ - these come in use for multiple projects)Add electric tape in board location if you don't want light coming through lighter colored filament prints ( test before final assembly in dark room ). With lighter filament colors, board LEDs (red - power / blue - charging) will show through which you may or may not like.(1) USB Type-A to Micro Type-B ( https://www.monoprice.com/product?p\_id=4867 )I like that I can just drop my phone into the cradle to charge without paying attention to lining up on my flat qi charger.Body was designed to be shorter for easy phone removal.Assemblyqi charger board presses in to place. A few dabs of hot glue will help keep the board in place (not necessary but a nice to have). Avoid gluing next to USB connector as there are holes in it which the glue can squish through ( don't ask how I found out ) :).rotate qi charger plate so conductor on top of coils sits in recess in body when assembled.you can place a few drops of super glue on body or back to glue halves together for a more solid build (my pic shows a gap as I didn't do this yet and was just test fitting things )All three m3 screws self tapPrint SettingsPrinter:Other Rafts: NoSupports: Yes Resolution: 0.2Infill: 15% Notes: Supports only needed for body.These support settings in prusa slicer made for easy/clean to remove supports for the body(thanks to Muppet Labs on Prusa forums):0.25mm z distance75% xy distance3mm support spacing4 interface layers0.2mm interface layer spacing   Category: Mobile Phone