Qbert Christmas Tree Ornament

thingiverse

I'd like to give credit where it's due - all the great work on this model belongs to metalnat. My kids had their hearts set on a Qbert Christmas tree ornament, so I went ahead and planted a torus at the top of his/her model as close to its center of gravity as possible and then connected the surfaces. This is my first attempt at a remix, so excuse any rough spots. Printer Settings Printer Brand: MakerBot Printer: MakerBot Replicator (5th Generation) Rafts: Yes Supports: Yes Resolution: High Notes: I tried this print without supports, but that didn't work out too well. Next, I attempted to lie the model flat and used supports, only to get a subpar result. It wasn't until I increased the resolution, added supports, and printed "standing up" (default position) that I achieved a near-flawless print.