QAV180 (210) XT60 + Antenna mount, HS1184 cam mount, LED bar

cults3d

Update: Camera mount strengthened some more. Update: The camera mount got a new revision that sets the camera angle to 30° to save manual adjustment. Update: The LED front mount was modified a bit. Better fit, and additional strength to act more like a bumper to protect the camera from taking a direct hit. Only 1g more weight. LEDs used are these, btw: http://www.banggood.com/LED-Decoration-Board-Strip-3S-For-QAV250-Quadcopter-p-951108.html Work fine on 4S too. Update: Slightly adjusted the camera mount width. Use M2x5 or M2x6 screws to mount camera, 2xM3x8 + 2x M3 lock nut to attach the mount. Currently doing a build based on a qav180 clone. In order to fit the rear xt60/antenna mount, you have to cut off the original one. This can be done simply with a dremel, standard cutoff wheel, and a steady hand. Medium speed, go slow. I can't stand dangling battery connectors, so this cleans it up nicely. All parts printed in PETG. Use high infill for strength. After test-fitting the XT60 (it should slide in fairly easily), apply a few drops of super glue on all four sides, slide it in, and let it dry for a few hours. Using that method, the only way to get it out was to break the mount along with it, so it should hold up good.