QAV-Cine Freybott Edition HDZero Camera Plates

thingiverse

V2 uploaded. After fitting v1 I noticed there's not a lot of room for uptilt with the HDZero rear cover attached. Have moved the camera mounting hole up 1mm and also thickened the main plate by 0.6mm to give a bit of extra rigidity. The tabs that fit through the top and bottom plates are still 1mm thick though, not much you can do about that. The new HDZero camera is a short boi and as such the frame is visible in view in the FPV feed. This design moves the camera forward about 5mm but still offers protection to the lens. Print it in the hardest material you have! PLA+ works but ABS would be best if you can. Designed for 0.2mm layer height as the depth is 1.6mm total (excluding the fitting tabs). I recommend 4 bottom layers, 4 top layers and 4 perimeters. It is designed to be a tight fit. Depending on your printer's tolerances you may need to file the tabs down slightly.