Qanba Drone Arcade Stick Wall Mount

thingiverse

I wanted to clear some clutter from my very limited shelf space so I created this wall mount to hold my arcade stick in place. The peg fits perfectly into the large holes at the back of the stick. To align the mounts on the back of the stick, I used a little tape, then attached removable glue dots to the backs of the mounts, allowing me to screw them into the wall once the stick was pressed against it. Printing this design upright eliminates the need for support under the peg. The hole is 4mm in diameter; I simply used some wood screws that were readily available in my garage. Now available in a new upgraded edition! Download now for chamfered pegs, reduced print times, and added aesthetic touches. This enhanced version features support-free printing and improved ease of insertion. My original versions are still functioning well, so I haven't had the chance to try out the new enhanced design yet. However, I felt it was time to make these improvements available for everyone else to enjoy.