Q-Tip Dispenser with Lid

prusaprinters

<p><strong>This sleek yet simple Dispenser keeps your Q-Tip's / Cotton-Swab's clean and ready for use.</strong></p><p>Rather simplistic on the outside, the internal geometry provides proper swap-feeding.<br><br><strong>Please keep in mind, that the q-tips have to be pushed down a little by hand through the slot for feeding the bottom tray. It was constructed sufficiently wide for this.</strong></p><p><strong>Printing Recommendations:</strong>&nbsp;<br>PLA, 0.2 mm layer hight, no supports needed,&nbsp;15 % infill, 3 perimeters.&nbsp;</p><p><strong>Tipp:</strong> Rotate the dispenser to it's normal upright position and it prints without supports!<br>Please see explanation below.</p><p><strong>Tipp:</strong> Should the swabs get stuck or tangled and not refeed the tray, just slightly push them down with a finger through the slot.</p><p><strong>Remark:</strong> The model was created by vinciusfelipe and licensed under CC Attribution.</p><p><strong>Update 07.09.2022:</strong>&nbsp;<br>Due to a much appreciated question here's a litte update regarding print orientation:&nbsp;</p><p>Picture below shows the correct print orientation. The bottom part of the slotted wall will be printed as an overhang and will most likely sag down a little. This should not affect functionality at all and extend is dependent on how well your machine is fine-tuned and how much part cooling it can provide. Please check comment section for more details.&nbsp;</p><figure class="image image-style-align-center image_resized" style="width:75%;"><img src="https://media.printables.com/media/prints/254667/rich_content/6daf3020-6895-4657-8430-ace259f7c35c/grafik.png#%7B%22uuid%22%3A%226d2e7ad8-84ac-48ac-81da-d847beb90256%22%2C%22w%22%3A1484%2C%22h%22%3A1132%7D"></figure><p>Hope you enjoy using this handy gadget as much as I do.</p><p>Happy printing!</p>