Pyronix Enforcer ENF 9.5" Android Tablet Wall Mount

cults3d

Wall mount designed for the 9.5 inch Pyronix ENF Android Tablet typically supplied with the Pyronix Enforcer V11 Security System. While this tablet is primarily intended to be used as an Alarm/CCTV panel, the tablet is open and can have standard home automation dashboards installed. Designed to use the 'left angle' 90 degree Micro-USB cable supplied with the tablet. The left angle StarTech USBAUB1MLA cable can also be used. UPDATE - March 2023 According to some owners, Pyronix have started supplying 'right angle' Micro-USB connectors which force the USB cable to run in the opposite direction (straight into the corner). There is now a Version 2 of the rear frame (original has been removed) that has been amended to allow for clearance of the USB connector and allow the cable to be routed over the top of the power switch extension. A spacer allows the tablet to 'float' away from the wall, while allowing the USB cable to enter a wall box. Mounting holes are provided for direct attachment to both UK (60mm hole spacing) and US (83.34mm hole spacing) single back boxes with additional mounting holes for screwing directly to a wall if needed. There is also an extension to the power button, allowing the tablet to be shut down/restarted while in the mount. WARNING - YOU NEED A BIG PRINT BED!!!! You will not be able to print this design on an Ender 3 or similar printer. *Minimum bed size requirement is 275mm (without skirt lines). * Prints in the images were produced on a Creality Ender 5 plus but they will quite happily fit on a CR-10 or other printer with a 300mm print bed. CHECK YOUR PRINTABLE AREA BEFORE BUYING - WE WILL NOT PROVIDE REFUNDS IF THIS DESIGN IS TOO BIG FOR YOUR PRINTER - YOU HAVE BEEN WARNED PERSONAL USE ONLY Files are provided for personal use only. Any/all commercial use is prohibited, as is sharing of files purchased.