Pxmalion T320 Y Heated Bed Plate

cults3d

This kit is designed to swap out the front and rear rails along with the belt anchor on your Y table travel, ensuring that the belt stays perfectly aligned with the center of the Y axis. The original setup's misalignment causes the heated bed to warp when moving from side to side, resulting in noticeable Y-axis artifacts in your prints. With this kit, you'll enjoy smoother prints and reduced noise along the Y axis, as well as longer lifespan for your linear bearings. To install it, simply drill two new holes for the heated bed plate's belt anchor - one centered on the plate itself and another just 2mm from the edge of the left linear bearing.