PVC end cap wrench (1.25" square)

prusaprinters

<p>The overflow drain on my in-ground pool was too low for my liking, so I capped it off. I now want to lower the water level a bit but couldn't easily remove the cap.</p> <p>The cap has a 1.25" square bolt-head, but is recessed in a fixture so I can't easily put a wrench on it. This tool fits over the bolt-head and extends out of the fixture far enough for me to turn. I added some holes to put a screwdriver (or other shaft) through for leverage if needed. (it was.)</p> <p>I was a little concerned that with 20% infill the tool wouldn't be strong enough, but it worked fine. I did need to put quite a bit of torque to get the plug out.</p> <h3>Print instructions</h3><p><strong>Printer Brand:</strong> Prusa<br/> <strong>Printer:</strong> <a href="http://amzn.to/2rqZ6Uo">i3 MK3</a><br/> <strong>Rafts:</strong> No<br/> <strong>Supports:</strong> No<br/> <strong>Resolution:</strong> 0.3mm<br/> <strong>Infill:</strong> 20%<br/> <strong>Filament:</strong> Amazon Basics PLA Green</p>