PVC canopy

prusaprinters

<p>A challenge was laid down infront of me to build a bed fort.</p> <p>Using the mounting holes for an upper bunk bed and 1in PVC, this was my answer.</p> <p>pieces:</p> <ul> <li>base mount . accepts the vertical and 45deg support. The 2 piece version allows for printing without supports and some versatility in mounting the frame to different surfaces. Adapters will be added as applications see fit.</li> <li>Corner. initially intended to use pieces from the hardware store, but none were available. this is an XYZ orientation that should be obvious. the flat back version needs no support.</li> <li>Strut support. Hollow piece slides freely to allow for fine tuning before tightening the set screw. 'Clean' version removed all the ugly failed seams, chamfers and pipes covering inconsistencies that I still haven't quite mastered.</li> </ul> <p>I printed these with 22% infill and 2mm walls. they shouldnt need the extra strength, but it couldnt hurt.</p> <p>Update 7/10/2019. replaced the threaded base with refactored internal thread.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Monoprice</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Select Mini</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>'normal'</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>22</p></div> <p><strong>Filament:</strong> Inland PLA+ Red</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>No supports are required only if printing the two remix pieces that dont need them. Orient the pieces so that the max angle is 45 and you should be fine. </p></div> </p></p></p> Category: Decor