Purge Bucket for CR10/Ender 3

thingiverse

This is a remix of the purge bucket by 3DMakernoob. Instead of a brush, there's a slot for a 33x15x3mm piece of silicone, taking its place. Without the silicone mat yet, I couldn't fit it in, so my work is put on hold. To print better results, I've also added a door that can be printed separately and then slid into place. Right now, the fit is very tight, but with some force, I was only able to slide the door in once. For easier access, I might make the tolerances less tight, allowing the door to be slid out and in smoothly. Printing this out of PETG instead of PLA makes sense. Yet, I haven't tested if PLA would stick to the bottom of the bucket when purging. This design will collide with the standard LCD on the Ender 3, so the LCD needs to be relocated elsewhere.