Punishing: Gray Raven - Inverse Shadow

cults3d

This model is cut into 6 parts to fit in my Ender 3 with platform size of 200m x 200m x 200mm. I also include an uncut version just in case you want to cut it yourself. All the parts are further cut into half for easy printing. All the pieces come with flat face that can lay on the printing bed easily. Tunnels of 10mm and 5mm diameter are punched on the model for alignment and bone installation purpose as well. The tunnels located on part 1 and 2 are quite near to the surface, please be extra careful when removing those. If you not good in removing support, you can use those tunnel as a guide and drill your own hole. Peg files also included just incase you can't find anything to help you with the alignment using the tunnels. "Peg" file is a cylinder with 9.5mm diameter for the bigger tunnel while "Peg4.5" are 4.5mm diameter for the smaller tunnel. Printing the pieces laying down save you more PLA as less support is needed and shorter printing time, but will have more obvious layer line on the surface. You can print them in upward position to minimize the layer line but result in longer printing time and more support needed. There is picture of pieces labelled to their file name in the preview section where you can refer to. Once printed, glue pieces a and b back to back using superglue to form a part. Repeat the same for all the other pairs and join them afterward. For scaling, please use the same scale factor for all the pieces. Cheers and Happy Printing!