Pumpkin Push-Ins Set 2

thingiverse

Print at your preferred Z height of 2, 3 or 4 mm. Resize X and Y to match the dimensions of your pumpkin perfectly. I use 20% infill, but you can choose any setting that suits you best. Attach a 1-inch nail to the back of your print, then push it firmly into a pumpkin. The nail's secure fit ensures it will stay in place, allowing you to turn it without it coming loose. When you're ready to remove the nail, simply pull it out - if you've used hot glue, the nail should detach easily. For a more permanent hold, consider using super glue or an alternative adhesive like jewelers glue, which I've found to be extremely effective. If necessary, adjust your print settings so that your pumpkin design lies flat on the printer bed, rather than standing vertically as shown in the pictures.