Pump Cover for a Hayward

thingiverse

This replaces the original clear cap and does not replace the white Black Cap piece shown in the image. Printed at 50% infill for added strength, using PLA material. Full supports were generated to prevent any potential issues due to the tight fit required for this design. Simply snap the clear part into place, then attach it to the pump. If there are any leaks, just adjust the alignment slightly. This design turns better than the original, resulting in a slightly looser fit, but once properly aligned, no issues occur. It took 17 hours to print using the flat side down orientation. After trying three different models, this one finally achieved zero leaking issues, and I hope it will work for you as well since it's all about millimeter precision. Do not adjust the scale under any circumstances.