Pulleys - Round

thingiverse

Sizes Available: 3/8 groove x3/8 bolt x2" diameter 1/4 groove x1/4 bolt x1-1/4" diameter. 1/8 groove x1/4 bolt x1-1/4" diameter (deep groove). Half the sizes come with numbers, while the other half does not. You can print two halves of your chosen size. The bolt holes were a bit tight for me, but they should work fine for a light press fit. I used a drill bit to enlarge them slightly. On March 19, 2016, I added a 3/8 pulley mount for extra shaft security. To attach it, slide the mount next to the pulley and drill into the pulley using a 5/64 drill bit. Then, use glue and 1.75mm filament to secure it in place. You may also want to add a set screw or pin for extra stability. Print Settings: Notes: PLA