Pug KeyChain

thingiverse

Customized version of http://www.thingiverse.com/thing:46704 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=46704 Instructions Using the following settings: rectangle_height is set to 60 pixels. A specific font, write/Letters.dxf, is used for writing. text1_tickness is precisely set at 3 pixels in thickness. The same thickness of 3 pixels applies to text2_tickness. text1_size has been optimized to 12 points. Height adjustments are made to 5 units. ring_y placement has been determined as 18 pixels from the top. A horizontal positioning of ring_x has been chosen, which is precisely 3 pixels from the left. text1_rotate has been calculated for a 350-degree turn counterclockwise. An inner ring with diameter 4 pixels in thickness exists below text1_rotate setting. The y-axis placement for text2 has been decided at -5 units below base. On the x-axis, 0 unit has been chosen as the leftmost position for placing text2. In contrast to that of text1_y which stands tall at +15, text2 has a negative positioning in terms of distance from its origin, being y= -15 away and then brought further down by a relative vertical placement value. On the right-hand side along this line with y=-15 where we found another element already positioned vertically lower than original position plus relative -10 unit so here’s text1's right edge being offset x units (-20 from its center). An image has been set: A friendly cute Pug. It’s placed as specified on the scene at scale factor equal one times. For this dog picture –no cutting will be done along circular boundary around central void area, since that variable cut_hole_in_image has got default value of Zero meaning not implemented. The width and radius respectively measure eighty units; hence for full-diameter thickness - or thickness value that represents difference between Outermost points we're using 7 pixels.