PSVR Processor Unit (CUH-ZVR2) Wall/Desk Mount

cults3d

This is a custom design I made for my PSVR Processor Unit. I needed to keep it out of the way while at the same time stop it from flying about while connected to the headset. I have modelled in some pilot holes but if you need to make them larger, I'm sure they will drill out using the usual methods. Holds the PSVR unit quite snuggly but is loose enough to slide out if necessary. If you are printing this without supports then be mindful of your bridging settings. Variants: PSVR PSU Mount no front.stl This was based on a Reddit post where someone flagged the possibility of overheating from the "top" of the unit While I've never had this problem myself (and apparently the 1st Gen PSVR Processing Unit had this issue) I have provided one with a large front vent. PSVR PSU Mount Vented logo.stl This is essentially the same as the Main Model but with the logo used as venting, I haven't tried to print this one, so I would be interested to see how that would turn out.