PSVR 2 Handed Rifle Adapter

thingiverse

Human: Gameplay Video - https://youtu.be/oej_kcawIRE Parts: (6) - m5 x 30mm Bolts (6) - m5 Hex Flange Nuts (6.5") - 1/2" PVC SoftTouch Self-Stick Non-Slip Surface Grip Pads - (6 pieces), 1" x 4" Strip - Black https://www.amazon.com/SoftTouch-Self-Stick-Non-Slip-Surface-Grip/dp/B000SL0KJC * Any adhesive padding will work Acetone (optional) Optional Stock ** Adjust to your preference (~17") - 1/2" PVC (2) - 1/2" PVC 90 degree elbows Print the Following: (1) - MoveAdapter_Front (1) - MoveAdapter_Rear (1) - FrontGrip (4) - Knob (2) - SmallKnob (6) - SwivelConnector Assembly Insert (4) 30mm bolts into the (4) Knobs Insert (2) 30mm bolts into the (2) SmallKnobs Insert (2) m5 Hex Nuts into MoveAdapter_Front Insert (2-3) m5 Hex Nuts into (2-3) of the (6) SwivelConnectors Depending on right or left handed, see attached images Attach 1 Grip Pad into FrontGrip to prevent the Front Move Controller from coming into contact with the Grip Cut (1) Grip Pad into (2) Small pieces Attach these to the inside of the MoveAdapter_Rear and MoveAdapter_Front to prevent the Read Move Controller from coming into contact with the Adapter, and to provide a tight fit Trim the Grip Pad to fit the inside of the Adapters Cut (3) pieces of PVC @ 2.5", 2.5" and 1.5" Insert (6) SwivelConnectors into the 3 pieces of PVC These should be a tight fit Assemble the parts using the attached images as a guide Stock The stock is more of a personal preference. Cut the PVC to a length that is comfortable for you. You can use various angled PVC elbows to make it a shape that you like. I also recommend using Acetone to glue the pieces of the Stock to make it as solid as possible ** I do not glue the Stock to the MoveAdapter_Rear, I leave it as a friction fit so that it can be removed Tips The 30mm bolts should slide freely in and out of the holes. I gently tap the bolts into the holes using hammer to ream the holes out Draw the 30mm Bolts into the knobs by aligning the hex shapes, I use a Hex Nut to draw them into place Align the hex nuts with their corresponding hex nut holes and draw them into place using a bolt If you are right handed, insert the knobs into the Swivel Connections from the Right so you can adjust them using your right hand If you are left handed, insert them from the Left Once you have assembled the adapter and confirmed that it is correct, (optionally) use Acetone to glue (5) SwivelConnectors to the PVC I use a Q-tip to spread a small amount of Acetone around each joint, this makes the adapter more solid and prevents the parts from moving, twisting or coming loose. The Acetone sets VERY quickly and is permanent, make sure the Adapter is aligned and assembled correctly before applying ** Do not use Acetone to glue the FrontGrip to it's Swivel Connector. This allows you to rotate the FrontGrip to switch between Right and Left Handed