PSU Cover

prusaprinters

<h3>PSU COVER 3D PRINTER</h3> <p>Shamelessly cloned from <a href="https://www.thingiverse.com/thing:2518780">Tevo Tarantula PSU Cover</a>, but made from scratch. 3D files attached, if someone wants to remix again.</p> <p><strong>NEEDED PARTS</strong></p> <ul> <li>3x <a href="https://www.banggood.com/5X-XT60-Male-Female-Bullet-Connectors-Plugs-For-RC-Battery-p-916559.html">XT60 connectors</a></li> <li>1x <a href="https://www.globalsources.com/gsol/I/DC-power/p/sm/1166344475.htm#1166344475">IEC 320 C14 Red Light Rocker Switch Fuse Inlet Male Connector Plug</a></li> </ul> <p><strong>INSTRUCTIONS</strong></p> <ol> <li>The 3 pin plug needs two M4 screws of at least 6-8 mm long and 2 nuts.</li> <li>The slot for the TX60 connectors is tight enough to hold them in place but just in case I superglued them to the walls.</li> <li>To hold the cover in place screw 3x M4 screws through the hole on the left/right sides to the hole on the PSU.</li> </ol> <h3>Print Settings</h3> <p><strong>Printer:</strong></p> <p>JGAurora A5s</p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div> <p><strong>Supports:</strong></p> <p>Yes</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0.2</p></div> <p><strong>Infill:</strong></p> <p>20%</p> <p><strong>Filament:</strong></p> Geetech PLA <p>Yellow</p> </p></p> Category: Electronics