PSA AKV-9 PIC RAIL STOCK ADAPTER

cults3d

UPDATE New model just uploaded 2/8 to correct dimensional issues with pic rail. Picatinny rail buttstock/brace adapter for Palmetto State Armory AKV-9. 100% original design created from measurements from legitimate AKV-9 from PSA. It is intended for an ultra tight fit, considering how sloppy the PSA made adapters are. That said, there MAY be a small amount of filing required on the side rails or bottom, in order to get a flush fit. Model will need some cleanup inside bolt slots. Price of STL and filament used is wellllllllll under what PSA charges for their adapter. Yes, theirs is metal. This one is a cheap DIY alternative. Hardware required: 2x 4mm nuts (square nuts preferred, hex nuts might fit a little too loose, depending on manufacturer). Reuse existing stock/brace screws. Assembly instructions: Slide square 4mm nuts into slots. Insert into rear trunnion. Bolt rear most screw first. Bolt front screw second. If front bolt causes gap at rear of adapter, loosen until gap disappears. DO NOT OVER TIGHTEN. Author does not give permission to use STL for commercial purposes. Personal use only. Use at own risk. Author not liable for misuse or injury from use of 3D printed components on a firearm.