PS5 Access Controller Finger Switch

PS5 Access Controller Finger Switch

thingiverse

Ongoing development - feedback welcome!Finger switch for the Playstation Access controller, with multiple mountings and optional spring to adjust resistance.Part of a collection of button caps and external switches for the Playstation Access controller:https://www.thingiverse.com/harakan/collections/41421121/thingsTo make a switch, three parts should be printed:Switch base with optional plateSwitch cap(s)Hinge pinFor each switch, you will also need:12mm x 12mm x 7.3mm tactile switch (e.g. https://www.digikey.com/en/products/detail/omron-electronics-inc-emc-div/B3F-5050/368377)3.5mm mono cable (e.g. https://www.digikey.com/en/products/detail/tensility-international-corp/10-00344/2350247)(Optional) 6.5mm x 10mm springSee the attached PDF for detailed assembly instructions ("Light_Touch_Switch_Assembly_Manual.pdf"), plus the additional assembly tips below.Five versions of the base are included, with single or double switches and an optional plate for stability:Single switchDouble switchSingle switch with plateDouble switch with plateDouble switch with plate and wider spacingTwo versions of the cap are included:Reverse (hinge towards cable). This allows an optional spring to be fitted to increase resistance, but the supports can be difficult to remove. This should be printed on its side, with full support.Original (hinge towards palm). This is easier to print, but the spring cannot be fitted. This should be printed on its side with support on the base plate only.Additional assembly tips:The hinge pin includes two different sizes; use the size that fits tightly but can be fully inserted. If neither size fits, try scaling the pin to 90%. When using the reverse cap, pressing the cable firmly down into the slot should avoid blocking the pin, but it might still be too thick. If so, put the pin in from one side as far as it will go and cut it, then do the same on the other side. For double switches, a thinner cable might be necessary.Revision HistoryVersion 1.0 (22-Feb-2024)Initial release

Download Model from thingiverse

With this file you will be able to print PS5 Access Controller Finger Switch with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on PS5 Access Controller Finger Switch.