PS4 Thumbstick Adaptors

prusaprinters

<p>This series of models hope to offer a variety of “swap-to-suite” PS4 thumbstick adaptors for adaptive play.</p><p><i>*Will likely be adding more/refining models. Open to suggestions, as each persons style of play may vary.&nbsp;</i></p><p>- - -&nbsp;</p><p><strong>Pinwheel</strong>- Basic Grip<br><br><strong>Anchor</strong>- Full, 6 Point, 5 Point</p><ul><li>Full- extended version of Pinwheel</li><li>6 Point- allowance for better access to D-pad/△, O, X, ▢</li><li>5 Point- more allowance for potential collision between joysticks</li></ul><p><strong>Rise</strong>- 18mm pad risen up 15mm</p><ul><li>Slice- trimmed one side for using two Rise adaptors at once</li></ul><p><strong>Arch</strong>- A rising arch that can place access to the thumbstick over the D-pad or △, O, X, ▢ buttons. Can also act as a handle to the thumb if positioned under the arch. <i>[Needs support*]</i></p><ul><li>Hook- slightly hooked end for better pull</li><li>Bulb- Reaches center of D-pad or △, O, X, ▢ (experimental inverse control)&nbsp;</li><li>Bulbv2- higher bulb version of ^<br>&nbsp;</li></ul><p>- &nbsp;- &nbsp;- &nbsp;</p><p>Tested, and best printed, upside down in TPU. No supports necessary [<i>unless noted*</i>]<br><br><i>Filament:</i> Polymaker's PolyFlex™ TPU95</p><p><i>Settings:</i> (used PrusaSlicer's “Fillamentum Flexfill 98A” filament profile)</p>