PS4 Pro Under Desk Mount

thingiverse

DISCLAIMER: Thingiverse and I are not responsible for any damage that may be caused from the use of this mount. Use at your own risk! Under desk mount for PS4 Pro. Print four and put two on each side of the PS4 Pro equally spaced apart. Features: 1) Mount leaves about 44mm of space between PS4 Pro and bottom of desk, providing additional storage space for an external hard drive, PSVR control unit, PSVR control unit power supply, game case storage, cable management, or anything else you would like to keep close to the PS4 Pro. 2) Designed to mount with common 3" drywall screws. I may upload designs for 2 1/2" and 2" if there is an interest. 3) Two screw holes so mounts do not move around when removing or inserting PS4 Pro. 4) Screw holes are spaced to allow a cordless drill to be used to drive drywall screws into bottom of desk. 5) Left space to allow 3" drywall screw would penetrate desk about 10mm. My desk is 3/4" thick, or about 20mm, so that 10mm won't protrude out the top or split the wood. 6) Does not need supports. 7) Takes about 30 minutes to print with 0.6mm nozzle at 0.4 height and 30% infill. 8) Cura says it uses about 16 grams of filament. 9) I did not put any tight areas in the STL so this should be printable even with large nozzles like 1.0mm. 10) The diamonds in the design are there to save print time and filament without affecting strength. Those diamonds decreased print time by 20% and filament usage by 20%. 11) The spaces within the mounts double as areas for cable routing. 12) These mounts are designed to be attached and PS4 Pro hung up underneath a desk by one person. THINGS TO REMEMBER: 1) If your table has a lip, make sure you give your PS4 Pro enough space to eject discs and slide the PS4 Pro out of the mounts if needed.